DAT Integration Process

DAT Integration Process

Integrating with DAT for any of the supported features is a two-step process.

1. Setup the Connexion interface with DAT
   1. EKA Solutions will contact DAT to initiate this process
   2. DAT will review the broker’s account and contact the broker to make any necessary subscription changes and to get the signed agreement for the Connexion services
   3. When DAT has completed the setup pieces on their side, they will provide the required credentials to the broker
2. Setup the Service Account with DAT - Load Post Service Only
   1. EKA Solutions will contact DAT to initiate this process
   2. DAT representative will contact the broker to set up the account
   3. DAT will complete the setup and ask the broker to complete the password setup
   4. Broker must provide the username and password for the service account to the EKA support team at support@go-eka.com
3. Setup the FTP Integration with DAT - Rate Contributor Service only
   1. Collaborate with DAT to establish the Rate Contributor file integration
   2. DAT will provide the necessary Accounting Number that is required to be in the header of the vile
   3. DAT will provide the FTP credentials
4. Configure EKA Omni TMS
   1. Add individual user credentials into the user's profile
   2. EKA Customer Success team will enter the remaining credentials and set CarrierWatch service levels where applicable

Integration is completed and immediately available for broker use as all of the setup steps are complete.

For more information on services offered with DAT click here.

For more details about the user credentials click here.

To get started on an integration with DAT contact the Customer Success team at support@go-eka.com.

For more information about DAT, visit www.dat.com.